Whisper 200 charge controller

isljc

I have a whisper 200 wind turbine.  I disconnected the turbine from the battery bank and when I reconnected it it didn't work. It had no lights on on the charge controller and it didn't charge.  I have power from the battery and the turbine at the controller. I have heard about the microprocessor latching up . Could this be the problem and if so how do I unlatch it

BB.

Don't know, but my suggestion...

First stop the blades from turning (tie with rope or no wind day).

Disconcert the battery power to turbine.

Wait 5 minutes.

Reconnect battery power.

Let blades spin.

Have you checked the brushes in the use bearing area (12vdc is getting through brush assembly to circuit board)?

Bill

jcisl90

I looking for a circuit board diagram for my whisper 200 charge controller.