Drink cooler as a battery box?

garynappi
garynappi Registered Users Posts: 120 ✭✭
in Solar Beginners Corner #1
I've got my small system laid out and working, and permanent assembly is getting near. I'm wondering about outdoor battery storage, heat and water intrusion into the storage area.

Right now I have a small utility shed (against a house wall in the shade of a tree) approximately 4' high, 4' across and 18" deep for the three 35ah AGM batteries. It's not insulated but could easily insulate it internally with spray expanding foam.

I'm wondering if a thermally insulated drink cooler would work better. Has anyone used a cooler for a battery box?
· Share on Twitter

Comments

  • mike95490
    mike95490 Solar Expert Posts: 9,583 ✭✭✭✭✭
    #2
    Water won't hurt the cases of the batteries much, but excess humidity can corrode any electronics.  Colder than 50f and battery capacity starts to really suffer, and warmer than 80f and lifetime shortens.   but a drink cooler would contain any cracked cases or spills.  You have to leave the lid open for venting.
    Powerfab top of pole PV mount | Listeroid 6/1 w/st5 gen head | XW6048 inverter/chgr | Iota 48V/15A charger | Morningstar 60A MPPT | 48V, 800A NiFe Battery (in series)| 15, Evergreen 205w "12V" PV array on pole | Midnight ePanel | Grundfos 10 SO5-9 with 3 wire Franklin Electric motor (1/2hp 240V 1ph ) on a timer for 3 hr noontime run - Runs off PV ||
    || Midnight Classic 200 | 10, Evergreen 200w in a 160VOC array ||
    || VEC1093 12V Charger | Maha C401 aa/aaa Charger | SureSine | Sunsaver MPPT 15A

    solar: http://tinyurl.com/LMR-Solar
    gen: http://tinyurl.com/LMR-Lister ,

    · Share on Twitter

Categories