Grid Voltage Drop - No solar power and errors
Options
gbaig
Registered Users Posts: 32 ✭✭
I am using schenider xw6048 inverter and compatible charge controllers. I am in Asia and we often have grid voltage drop from 220V to 200 or less during the daylight. In this case system stops producing solar power. The only solution that I know is to disconnect grid power. Does anyone have any other solution?
Comments
-
What is your desire?
Do you want the XW to continue to use AC grid power at 200 VAC? Or do you want it to switch over to battery power at that point?
-Bill
Near San Francisco California: 3.5kWatt Grid Tied Solar power system+small backup genset -
Maybe a transformer that will provide a 8% boost and either switch it in or leave it in all the time (depending on what your max voltage is).
I am available for custom hardware/firmware development
Categories
- All Categories
- 243 Forum & Website
- 150 Solar Forum News and Announcements
- 1.4K Solar News, Reviews, & Product Announcements
- 191 Solar Information links & sources, event announcements
- 919 Solar Product Reviews & Opinions
- 256 Solar Skeptics, Hype, & Scams Corner
- 22.5K Solar Electric Power, Wind Power & Balance of System
- 3.5K General Solar Power Topics
- 6.7K Solar Beginners Corner
- 1K PV Installers Forum - NEC, Wiring, Installation
- 2.1K Advanced Solar Electric Technical Forum
- 5.5K Off Grid Solar & Battery Systems
- 438 Caravan, Recreational Vehicle, and Marine Power Systems
- 1.1K Grid Tie and Grid Interactive Systems
- 652 Solar Water Pumping
- 829 Wind Power Generation
- 626 Energy Use & Conservation
- 626 Discussion Forums/Café
- 303 In the Weeds--Member's Choice
- 91 Construction
- 124 New Battery Technologies
- 108 Old Battery Tech Discussions
- 3.8K Solar News - Automatic Feed
- 3.8K Solar Energy News RSS Feed