Magnun MMS1012 only delivers 8 AMPS when charging
billnax
Registered Users Posts: 1 ✭
The MMS1012 in my system will only output 8 AMPS when charging. Would original show 30A. I've checked and rechecked all the settings but still can't get but 8 Amps. Any information would be extremely helpful.
Tagged:
Comments
-
Welcome to the forum Billnax,
I don't have anything specific to answer... I would suggest starting with the basics. Use a good quality DMM and measure voltages at the inverter (DC battery bus terminals), AC input/output terminals, under load, and idling.
It is not unusual to find loose or dirty connections.
-BillNear San Francisco California: 3.5kWatt Grid Tied Solar power system+small backup genset -
Are you sure that the charge cycle is not in Absorb or Float ?
Categories
- All Categories
- 220 Forum & Website
- 128 Solar Forum News and Announcements
- 1.3K Solar News, Reviews, & Product Announcements
- 189 Solar Information links & sources, event announcements
- 886 Solar Product Reviews & Opinions
- 254 Solar Skeptics, Hype, & Scams Corner
- 22.3K Solar Electric Power, Wind Power & Balance of System
- 3.5K General Solar Power Topics
- 6.7K Solar Beginners Corner
- 1K PV Installers Forum - NEC, Wiring, Installation
- 2K Advanced Solar Electric Technical Forum
- 5.5K Off Grid Solar & Battery Systems
- 424 Caravan, Recreational Vehicle, and Marine Power Systems
- 1.1K Grid Tie and Grid Interactive Systems
- 651 Solar Water Pumping
- 815 Wind Power Generation
- 621 Energy Use & Conservation
- 608 Discussion Forums/Café
- 302 In the Weeds--Member's Choice
- 74 Construction
- 124 New Battery Technologies
- 108 Old Battery Tech Discussions
- 3.8K Solar News - Automatic Feed
- 3.8K Solar Energy News RSS Feed