morningstar prostar 25 issues
Options
sunnyskies
Registered Users Posts: 14 ✭✭
The controller works fine but when hooking up remote meter (rm-1) the meter boots up no errors logged and I get backlight amp hr production but no voltages for array and batt also no other amp readings. local and remote temp sensors are also indicated. tried 2 different rj11 cables and of course rebooting the controller. running v 1,10 anyone have any idea whats up with this?
Comments
-
There was a firmware update on the 19th of January this year to V14.
Another possibility is the remote meter is installed incorrectly.
Check all connections again. -
morningstar is sending meter with updated firmware and a mailer for the old one awsome tech support
-
wheres my manners!? thanks solray for your input! will report back on results
-
Categories
- All Categories
- 243 Forum & Website
- 150 Solar Forum News and Announcements
- 1.4K Solar News, Reviews, & Product Announcements
- 191 Solar Information links & sources, event announcements
- 919 Solar Product Reviews & Opinions
- 256 Solar Skeptics, Hype, & Scams Corner
- 22.5K Solar Electric Power, Wind Power & Balance of System
- 3.6K General Solar Power Topics
- 6.7K Solar Beginners Corner
- 1K PV Installers Forum - NEC, Wiring, Installation
- 2.1K Advanced Solar Electric Technical Forum
- 5.5K Off Grid Solar & Battery Systems
- 438 Caravan, Recreational Vehicle, and Marine Power Systems
- 1.1K Grid Tie and Grid Interactive Systems
- 652 Solar Water Pumping
- 829 Wind Power Generation
- 626 Energy Use & Conservation
- 628 Discussion Forums/Café
- 303 In the Weeds--Member's Choice
- 91 Construction
- 126 New Battery Technologies
- 108 Old Battery Tech Discussions
- 3.8K Solar News - Automatic Feed
- 3.8K Solar Energy News RSS Feed