mpp 8048 inverter wire connection yo pcb

robocop
robocop Registered Users Posts: 118 ✭✭
in Solar Beginners Corner #1
took the cap of the inverter and there was  a wire loose  checked out this wire came from the N7 position near the screen pcb..

Ask the ttechnician of mpp about this to show me where it should be attached but wont listen to me  just want me to go to check with multimeter elsewhere.
Isd there somebody who can help me with this?
Bob
· Share on Twitter

Comments

  • littleharbor2
    littleharbor2 Solar Expert Posts: 2,101 ✭✭✭✭✭
    #2
    You may find someone with an answer at the DIY Solar forum.

    2.1 Kw Suntech 175 mono, Classic 200, Trace SW 4024 ( 15 years old  but brand new out of sealed factory box Jan. 2015), Bogart Tri-metric,  460 Ah. 24 volt LiFePo4 battery bank. Plenty of Baja Sea of Cortez sunshine.

    · Share on Twitter
  • BB.
    BB. Super Moderators, Administrators Posts: 33,613 admin
    #3
    I think this is the forum littleharbor2 is suggesting;

    https://diysolarforum.com/

    -Bill
    Near San Francisco California: 3.5kWatt Grid Tied Solar power system+small backup genset
    · Share on Twitter

Categories