Torque Wrench recommendation
Options
citysnaps
Registered Users Posts: 8 ✭
I'm looking for recommendation for a small 1/4" drive torque wrench in the 10 - 200 inch-pound range, suitable for electrical terminals - both nut and screw.
Any tool stand out as a good value?
Thanks...
Any tool stand out as a good value?
Thanks...
Comments
-
Re: Torque Wrench recommendation
A gunsmithing tool like this one at amazon does the job. There are other brands available in gunsmithing tools. I've used one for years for all sorts of small screws.Northern NM, 624 watts PV, The Kid CC, GC-2 batteries @ 24 VDC, Outback VFX3524M -
Re: Torque Wrench recommendation
Thanx, Don - appreciate it!
Categories
- All Categories
- 243 Forum & Website
- 150 Solar Forum News and Announcements
- 1.4K Solar News, Reviews, & Product Announcements
- 191 Solar Information links & sources, event announcements
- 919 Solar Product Reviews & Opinions
- 256 Solar Skeptics, Hype, & Scams Corner
- 22.5K Solar Electric Power, Wind Power & Balance of System
- 3.5K General Solar Power Topics
- 6.7K Solar Beginners Corner
- 1K PV Installers Forum - NEC, Wiring, Installation
- 2.1K Advanced Solar Electric Technical Forum
- 5.5K Off Grid Solar & Battery Systems
- 438 Caravan, Recreational Vehicle, and Marine Power Systems
- 1.1K Grid Tie and Grid Interactive Systems
- 652 Solar Water Pumping
- 829 Wind Power Generation
- 626 Energy Use & Conservation
- 626 Discussion Forums/Café
- 303 In the Weeds--Member's Choice
- 91 Construction
- 124 New Battery Technologies
- 108 Old Battery Tech Discussions
- 3.8K Solar News - Automatic Feed
- 3.8K Solar Energy News RSS Feed